Maytag NEPTUNE WASHER Manuel d'utilisateur télécharger pdf (Page 11)

Before You Call ........................................... ....... .

For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care proce-

dures, see the enclosed Laundering Tips booklet.

Check these points if your Maytag Neptune TM washer...

• Use Max Extract option.

Load Is Too Wet at • Try using a high efficiency detergent to reduce sudsing.

End of Cycle • Load is too small. Very small loads (one or two items) may not

spin out completely.

• ....o**.........**** ........ ,**o.........ool***....... e*oo* o.......ooo ***.......I * ***....... • • o*......... • ***... ,.... ****-... ,-* •

• Door firmly closed.

• Make sure hose connections are tight.

Leaks Water • Make sure end of drain hose is correctly inserted and secured to drain facility.

• Avoid overloading.

• Use high efficiency detergent to prevent over-sudsing.

• Check fuse or reset circuit breaker.

• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for

service.

Won't Spin or • Close the door and push the START/STOP button. For your safety, washer will not

Drain tumble or spin unless the door is closed.

• After pressing the START/STOP button, it may take a few moments before the clothes

washer begins to spin. The door must lock before spin can be achieved.

• See "Tub is Completely Full of Suds" below.

• Plug cord into live electrical outlet.

• Check fuse or reset circuit breaker.

• Turn the control dial to proper cycle and push the START/STOP button to

start the clothes washer. If equipped with buttons, be sure they are fully depressed.

Stops • Close door and push the START/STOP button to start the clothes washer. For your

safety, washer will not tumble or spin unless door is closed.

• This may be a pause or soak period in the cycle. Wait briefly and it may start.

• Check screens on inlet hoses for obstructions. Clean screens periodically.

• o...,.*o*.*.....Qoo*....... D**o.---.---•• .---.---•*''''''''''*''''''''''**'''''''''**''''''''" •*''''''''**''''''" •***'''''''*•* "

Tub is • Run the clothes washer through another complete cycle using cold water.

Completely • Reduce detergent amount for that specific load size, soil level and water hardness.

Full of Suds • Use high efficiency or low sudsing detergent specially formulated for front load washers.

....o***......oo• i......•oo4 ......o•**o........o........ Io.ol......ooe•l......oooo......• •*.o......***.---...o**-..---. •**'''''" *

• Turn both faucets on fully.

• Check that the temperature selector button is fully depressed.

• Make sure temperature selection is correct.

• Make sure hoses are connected to correct faucets and inlet connections. Flush water

line before filling washer.

Fills with • Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water

the Wrong at the tap. Also check water heater capacity and recovery rate.

Temperature • Disconnect hoses and clean screens. Hose filter screens may be plugged.

Water • When warm rinse is selected, only the final rinse will be warm. The first two

rinses will be cold.

• While the washer is filling for cold or warm wash temperatures, both hot and cold

water will go through the dispenser as the automatic temperature control feature checks

incoming water temperatures. This is normal.

..*•.......**o......*..**..., ._**-...-_*o._.-_-_**o._..-_-_**._._-•**o._._--_oo.._-_-_oo._.-_*o_.----_*..- •

1 2 ... 6 7 8 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire

Maytag NEPTUNE WASHER Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Maytag NEPTUNE WASHER