Maytag MGR5751BDW Instructions d'exploitation télécharger pdf (Page 4)

PARTS supplied for installation:

able tie to secure drain hose to standpipe,

inlet hose or laundry tub

Beaded tie to secure drain hose to cabinet (if required)

washers and 2 screens for water hoses

STEP 1

PREPARE WASHER

1. Remove tape on lid. Remove accessory package from tub.

2. Tip the washer backward. Loosen front leveling leg lock nuts.

3. Tip washer slightly forward. Loosen rear leveling leg lock nuts.

REMOVE THE TUB BLOCK.

5. Remove the inlet hoses.

STEP 2

INSTALL WASHER

WATER SUPPLY

Cold water supply:

Pressure: 0.14–0.8 MPa (20–120 p.s.i)

Temperature:

°C max. (77°F max.)

Hot water supply:

Pressure: 0.14–0.8 MPa (20–120 p.s.i)

Temperature: 49°C—60°C (120°F—140°F)

These water pressures are required to correctly fill the washer in the proper time. Pressures of less than

0.14 MPa may cause a failure in the machine water valve, and it may also not shut of

f completely.

Fit water supply stop-taps to allow easy disconnection of fill hoses. Always turn taps off when washer is not in

use (make sure they are accessible).

This appliance should be connected to the water supply using the new hose-sets supplied with it. Old

hose-sets should not be reused.

ELECTRICAL

WARNING—

This is a 3-wire appliance which must be earthed.

The washer is fitted with an electrical supply cord and a selection of plugs. Select the plug which matches

your socket-outlets, and connect to the in-line connector using the snap-fit cover provided. It should be

connected to an electricity supply socket at the voltage shown on the data plate. The minimum supply fuse

capacity should be 13A.

The washer must be positioned so that the plug is accessible. If the supplied plugs

are not suitable, the electrical connection must be carried out by a competent electrician in accordance with

local or national wiring regulations.

Locking cam

1 2 3 4 5 6 7 8 9 ... 14 15

Pas de commentaire

Maytag MGR5751BDW Instructions d'exploitation Page 4