Maytag MMV6190DS Guide d'installation

MICROWAVE HOOD COMBINATIONINSTALLATION INSTRUCTIONSMICROWAVE HOOD COMBINATION SAFETY W10652353AThis product is suitable for use above electric or gas

10NOTE: If microwave oven does not need to be adjusted, skip steps 7-9.7. If adjustment is required, rotate microwave oven downward. Using 2 or more p

11VENTING DESIGN SPECIFICATIONSThis section is intended for architectural designer and builder/contractor reference only.NOTES: Vent materials needed

Recommended Vent LengthA 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent should be used.The total length of the vent

2INSTALLATION REQUIREMENTSTools and PartsTools NeededGather the required tools and parts before starting installation. Read and follow the instruction

3Installation DimensionsNOTE: The grounded 3 prong outlet must be inside the upper cabinet. See “Electrical Requirements” section.*30" (76.2 cm)

4INSTALLATION INSTRUCTIONSRemove Mounting PlateDepending on your model, the mounting plate may be in the foam packaging, or it may be attached to the

57. Reattach blower motor to back of microwave oven with 2 screws removed in Step 3.8. Reattach damper plate. Make sure damper plate tabs are inserted

6Locate Wall Stud(s)NOTE: If no wall studs exist within the cabinet opening, do not install the microwave oven.See illustrations in “Possible Wall Stu

7Mark Rear WallThe microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of 1 lag screw, preferably 2.1. Using m

8Installation for Wall Stud at One End Hole (Figure 3)1. Drill a 3/16" (5 mm) hole into the wall stud at the end hole marked in Step 3 of “Mark R

95. Cut the 1¹⁄₂" (3.8 cm) diameter hole at the circular shaded area “G” on the template. This hole is for the power supply cord.NOTE: If upper c