Maytag MVWB965HC Manuel d'installation télécharger pdf (Page 4)

INSTALLATION INSTRUCTIONS

Before you start:

Remove shipping materials

It is necessary to remove all shipping materials for proper

operation and to avoid excessive noise from washer.

Move washer to within 4 ft (1.2 m) of its ﬁnal location; it must

be in a fully upright position.

NOTE: To avoid ﬂoor damage, set washer onto cardboard

before moving it and make sure lid is taped shut.

To avoid damaging ﬂoor, place cardboard supports from

shipping carton on ﬂoor behind washer. Tip washer back

and place on cardboard supports. Remove shipping base.

Set washer upright.

IMPORTANT: Removing shipping base is necessary for proper

operation. If your washer includes a sound shield, please refer

to the instructions included with the sound shield to install it at

this time.

Electrical Requirements



A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply

is required. A time-delay fuse or circuit breaker is recommended.

It is recommended that a separate circuit breaker serving only this

appliance be provided.

This washer is equipped with a power supply cord having

a 3 prong grounding plug.

To minimize possible shock hazard, the cord must be plugged

into a mating, 3 prong, grounding-type outlet, grounded in

accordance with local codes and ordinances. If a mating outlet

is not available, it is the personal responsibility and obligation

of the customer to have the properly grounded outlet installed

by a qualiﬁed electrician.

If codes permit and a separate ground wire is used, it is

recommended that a qualiﬁed electrician determine that

the ground path is adequate.

Do not ground to a gas pipe.

Check with a qualiﬁed electrician if you are not sure the

washer is properly grounded.

Do not have a fuse in the neutral or ground circuit.

1. Move washer

48"

(1.2 m)

2. Remove shipping base

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Maytag MVWB965HC Manuel d'installation Page 4