Maytag MVWB965HC Manuel d'installation télécharger pdf (Page 5)

Remove tape from washer lid, open lid, and remove foam

packing ring from tub. Be sure to remove all parts from tray.

NOTE: Keep tray in case you need to move washer later.

Firmly grasp power cord plug and pull to free from rear panel.

Gently place power cord over console to allow free access

to back of washer.

Connect Drain Hose

Place hose into standpipe (shown in picture) or over side of

laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.

3. Remove packing tray from tub

4. Free power cord

6. Place drain hose in standpipe

4.5"

(114 mm)

Drain

hose form

If clamp is not already in place on elbow end of drain hose,

slide it over end as shown. Squeeze clamp with pliers and

slide black elbow end of drain hose onto black drain port

and secure with clamp.

For a laundry tub or standpipe drain, go to Step 6.

For a ﬂoor drain, remove the preinstalled drain hose form as

shown in Step 7. You may need additional parts with separate

directions. See “Tools and Parts.”

5. Attach drain hose to drain port

Drain

hose form

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Maytag MVWB965HC Manuel d'installation Page 5