Maytag MGR5751BDW Instructions d'exploitation télécharger pdf (Page 5)

If the supply cord is damaged, it must be replaced with a specially terminated cord by an authorized service

agent or a similarly qualified person in order to avoid a hazard.

Do not connect via a cord extension set or electrical portable outlet device.

HOSE CONNECTION

1. Never reuse old hose sets. Insert the rubber hose washer from accessory pack-

age into the SAE threaded end of the inlet hose. The SAE threaded end is point-

ed to by the flow arrow on the hoses. Attach the inlet hoses to the HOT and

COLD connections of the water valve on the back of the washer with the flow

arrows pointing into the machine. HOT and COLD connections are identified by

H & C stamped on the bracket, HOT on top, COLD on bottom. Be sure the hose

marked “HOT” is attached to the HOT connection. When connecting the inlet

hoses, be sure the hose connections are not cross-threaded on the water valve.

Tighten by hand until snug and then two-thirds of a turn with pliers. Do not over-

tighten as this will strip threads on the water valve.

2. Insert both a rubber hose washer and a screen into the hoses for the tap

connections. The dome on the screen strainer must point towards the tap.

Attach the inlet hoses to the HOT and COLD taps, being sure the hose marked

“HOT” is attached to the HOT

water

tap. NOTE: Accessory inlet hoses

are available in various lengths up to

3m (10 ft.).

3. Place the drain hose in the drain

facility. To change drain hose direc-

tion or prevent collapsing, turn the

short end of the hose while holding

the base of the hose stationary.

NOTE: If you must make an airtight seal, use a floor

drain, or if the standpipe is not at least 91cm (36 in.), a

siphon break kit must be used (see Siphon Break

installation).

The drain hose should be tied down with

the cable tie provided.

4. Slide the washer into position.

Do not collapse or

damage the drain hose.

5. Level the washer by turning the leveling legs in or out

as necessary. When the washer is level, tighten the

leveling lock nuts.

OSE

RETAINER

Hose

Retainer

Hose

Retainer

1 2 3 4 5 6 7 8 9 10 ... 14 15

Commentaires sur ces manuels

Pas de commentaire

Maytag MGR5751BDW Instructions d'exploitation Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Maytag MGR5751BDW