Maytag MDE25PN Spécifications télécharger pdf (Page 4)

INSTALLATIONREQUIREMENTS

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools

listed here.

Tools needed:

m 200 mm (8") or 250 mm m 8 mm (5/16") socket

(10") Pipe wrench wrench

m 200 mm (8") or 250 mm m Utility knife

(10") Adjustable wrench m Vent clamps

m Flat-blade screwdriver m Sealing compound gun

m Phillips screwdriver and sealing compound (for

m Adjustable wrench that installing new exhaust vent)

opens to 25 mm (1") or m Pliers

hex-head socket wrench m Stiff-bladed putty knife

m Level

Parts supplied:

Remove parts bag from dryer drum. Check that all parts were

included.

[] Foot boot (4) [] PN models: Card reader

[] Dryer foot (4) bezel, card reader wire

harness, hardware

[] PD models: Cam for

service door lock

NOTE: The circuit diagram for this dryer is located inside the

lower front panel, within the Tech Sheets.

Technical

Specifications:

220-240 v, 50 Hz. AC

4575W

Total mass: 68 kg max.

Clothes Capacity:

9 kg max.

NOISE: Sound Pressure Level, Lpa: 58 dBA (uncertainty,

Kpa: +/-10 dBA).

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from dryer.

Do not install in a garage.

Failure to do so can result in death, explosion, or fire.

IMPORTANT: Observe all governing codes and ordinances.

[] Check code requirements: Some codes limit or do not permit

installation of clothes dryers in garages, closets, or sleeping

quarters. Contact your local building inspector.

[] Do not install on carpet.

NOTE: The dryer must not be installed in an area where it will be

exposed to water and/or weather.

Recessed Area and Closet Installation Instructions

This dryer may be installed in a recessed area or closet. This

dryer must not be installed behind a lockable door, a sliding door,

or a door with a hinge on the opposite side to that of the dryer.

The installation spacing is in millimeters and is the minimum

allowable. Additional spacing should be considered for ease

of installation, servicing, and compliance with local codes

and ordinances.

If installed in a closet with a door, the minimum unobstructed air

opening in the top and bottom is required. Louvered doors

with equivalent air openings are acceptable.

The dryer must be exhausted outdoors.

No other fuel-burning appliance may be installed in the same

closet as the dryer.

Minimum Installation Clearances

381 mm

Os")

o o

I I

Ornrn _ Ornrn

CO") _ CO")

Recessed front view

356 mm

C14'') max

Closet

door

(:1

! .... ]

'' _ Omm

(0")

_1 ]_2s mm11")

Closet side view

Additional clearances may be required for wall, door, and floor moldings or if

external exhaust elbow is used.

(48 in._)

Front

view

(24 in._)

76 mm (3")

closet

door

76 mm (3")

*Opening is the minimum

for a closet door. Louvered

doors with equivalent air

openings are acceptable.

1 2 3 4 5 6 7 8 9 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Maytag MDE25PN Spécifications Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique Maytag MDE25PN